The Gutter Shutter system has been designed and tested to handle the heaviest rainfalls. Both the 5″ and the 6″ hood have exclusive flow reducers that slow the water coming off your roof. However, it’s the principle of surface tension that keeps the water flowing into the gutter. Surface tension isn’t affected by the amount or speed of the water flowing so even in the heaviest rainfalls, Gutter Shutter will still work smoothly.

The steeper the roof, the better Gutter Shutter performs. The funny thing about roofs is that the steeper they get, the less water they catch. A flat roof catches all of the rain that falls over it. As you begin to tilt a flat roof upward, angling its surface to the rain, you reduce the surface area that can catch rain and reduce the total amount of rain to be handled by the gutter. Granted, the water that is caught will flow faster but, fast water flow has no effect on how Gutter Shutter performs.

The Gutter Shutter system is made with 0.032 thick aluminum – the strongest application used for a residential application. Standing a ladder or other similar device against the Gutter Shutter system is not a problem.

The Gutter Shutter attaches directly to the fascia board, in no way interfering or associated with the roof.

Gutter Shutter completely encloses and protects. There are no vertical openings for water or clogging debris to enter, and no screens, inserts or filters to clog. Rainwater flows over and around the nose of the Gutter Shutter by the simple physical law of water surface tension. It’s just like the way water clings to the side of a glass when it’s poured. The Gutter Shutter System has more surface tension than any other system. This will afford you the peace of mind that comes with knowing you no longer will be putting anyone’s health or safety at risk that comes with climbing the ladder to clean your gutters. Your fascia is no longer at risk of additional rotting as the exclusive High Back system ensures your board is covered in aluminum, adding to Gutter Shutter’s water management features.

When it comes to covered gutters, one-piece designs simply don’t make sense. Because the top and bottom are made in one piece, if either piece gets damaged they both need to be replaced. And because the top isn’t removable it’s very hard to clean or service the gutter. The newest state-of-the-art integrated gutter systems use a two-piece technology. The top is a separate piece that can be replaced if damaged without replacing the seamless gutter. One type uses a snap on hood but snap on hoods can be easily damaged or blown off in high winds. Gutter Shutter’s two-piece design secures the separate hood to the bracket and trough. The secured hood is very strong – it can’t be blown off by the wind and allows easy access if service is ever needed.

It’s more likely, over time, that your old gutters will cause as much as 10 times their value in home repairs because of poor design. It simply doesn’t make sense to keep them! Companies selling products that rely on using your old gutters want you to believe that you’re going to save a lot of money by a lower initial cost. The truth is you can install a complete Gutter Shutter system for the same or less money, and you can rely on our lifetime guarantee of a product that will hold up over time! Ask your Gutter Shutter representative about our “Best Value Guarantee.”